Turbosorp湍流吸收循环流化床烟气脱硫技术在改造工程中的应用

循环流化床半干法烟气脱硫技术是目前世界上主流脱硫工艺技术之一,主要适用于大中型燃煤电厂的烟气脱硫,在国内外拥有大量成功运行的工程案例。本文章基于本公司实践论述Turbosorp湍流吸收循环流化床脱硫技术的技术特点、关键工艺控制要点以及在机组改造工程中的技术优势,为同类型机组改造工程中的方案选择提供参考。     

Enhanced struvite recovery from wastewater using a novel cone-inserted fluidized bed reactor

The feasibility of struvite recovery at low （12.5 mg/L） and high （120 mg[L） phosphorus concentrations was studied by constructing a novel fluidized bed reactor with cones （FBRwc） and without cones （FBRwoc）. The crystallization process was continuously operated for 133 days under different hydraulic retention times （HRT = 1-10 hr）, pH （7.5-10）, and molar ratios of Mg/P （0.75-1.75）, N/P （1-10） and Ca/Mg （0-2）. The optimum operating conditions of HRT, pH, Mg/P and N/P molar ratios were found to be 2 hr, 9, 1.25, and 7.5, respectively. Under these optimum conditions, the phosphorus precipitation efficiencies of FBRwc were 93% for low and 98% for high phosphorus influent; however, the efficiencies were 78% and 81% for FBRwoc, respectively. Due to crystal losses at each junction （17%-31%）, the crystal recovery efficiency of FBRwoc was relatively low （47%-65%） for both influent concentrations. However, the losses were minimal in FBRwc, which showed 75% and 92% crystal recovery for low and high phosphorus concentrations, respectively. At low calcium concentration, crystal chemical analysis showed the product to be pure struvite （〉 99%）. The scanning electron microscope and X-ray diffraction results further confirmed that the crystal recovered from FBRwc contained pure struvite, which could be considered a high quality fertilizer. Except HRT, all parameters （pH, Mg/P, N/P and Ca/Mg） were found to be influencing factors for FBRwc performance. Overall, inserting cones in each part of the reactor played a significant role in enhancing struvite recovery from a wide range of phosphorus-containing wastewater.     

A restoration-promoting integrated floating bed and its experimental performance in eutrophication remediation

Numerous studies on eutrophication remediation have mainly focused on purifying water first, then restoring submerged macrophytes. A restoration-promoting integrated floating bed （RPIFB） was designed to combine the processes of water purification and macrophyte restoration simultaneously. Two outdoor experiments were conducted to evaluate the ecological functions of the RP1FB. Trial 1 was conducted to compare the eutrophication purification among floating bed, gradual-submerging bed （GSB） and RPIFB technologies. The results illustrated that RPIFB has the best purification capacity. Removal efficiencies of RPIFB for TN, TP,NH4＋-N, NO3-N, CODcr, Chlorophyll-a and turbidity were 74.45%, 98.31%, 74.71%, 88.81%, 71.42%, 90.17% and 85%, respectively. In trial 2, influences of depth of GSB and photic area in RPIFB on biota were investigated. When the depth of GSB decreased and the photic area of RPIFB grew, the height of Potamogeton crispus Linn. increased, but the biomass of Canna indica Linn. was reduced. The mortalities of Misgurnus anguillicaudatus and Bellamya aeruginosa in each group were all less than 7%. All results indicated that when the RPIFB was embedded into the eutrophic water, the regime shift from phytoplankton-dominated to macrophyte-dominated state could be promoted. Thus, the RPIFB is a promising remediation technology for eutrophication and submerged macrophyte restoration.     

流化床O2/CO2气氛燃煤痕量元素的排放特性及控制

通过平顶山烟煤在小型流化床中的燃烧实验,采用X-射线荧光光谱仪(XRF)对低压撞击器(LPI)收集到的细颗粒物元素组成进行定量测定,研究了O2/CO2气氛下硅藻土对煤粉燃烧痕量元素的排放控制.结果表明,Zn、Mn和Ni的含量随粒径呈双峰分布,峰值分别在0.1μm和2μm附近,Hg和Co的含量在0.1μm附近有一峰值;Hg和Zn在亚微米颗粒上有一定程度的富集,Mn、Ni和Co在亚微米和超微米颗粒上的含量基本相当;当颗粒物粒径一定时,随着硅藻土含量的增加,5种元素的富集因子呈减小的趋势;随着添加剂粒径的减小,颗粒物中Hg、Mn、Zn、Ni和Co的含量呈减少的趋势;当颗粒物粒径一定时,5种元素含量顺序为MnZnNiCoHg.     

畜牧业清洁生产关键技术实例研究——生态发酵床在规模化养猪场的应用研究

畜牧养殖业最大的污染物就是畜禽粪便,在畜禽养殖也实施清洁生产技术十分必要,将粪便在产生的环节上降低污染物的产生和排放,结合具体实例,按照企业清洁生产审核程序要求,对一家生猪养殖场进行清洁生产审核,对生态发酵床技术在规模化养猪场的应用进行深入研究,从技术、环境、经济三个方面阐述这项清洁生产技术的示范作用。     

波流式生态滤床氨氮去除效果及其微生物群落结构分析

利用波流式生态滤床处理受污染的河水,考察了其对氨氮的去除效果和沿程污染物转化情况,并采用扫描电镜、高通量测序手段解析了波流式生态滤床不同时间和位置基质上生物膜的细菌群落组成,分析了波流式生态滤床小试反应器中硝化细菌和反硝化细菌的分布特点,以探讨其去除氨氮的机理.结果表明,反应器稳定运行以后,对氨氮平均去除率为74.83%,基质表面可以观察到大量微生物,不同时期优势细菌有较大不同.反应器前部主要发挥硝化作用,中部发挥反硝化作用,硝化菌的分布呈现上多下少、前多后少的特点,使得氨氮在前端被快速去除;中部以黄杆菌属(Flavobacterium)为代表的反硝化菌丰度较高,促进了反硝化作用的发挥,降低了出水中总氮浓度;不同部位样品中细菌多样性差别不大,微生物种群多样性随着水流方向呈现先增加,到后段减少的趋势.     

并流旋转床气体出口压降数值分析

气体出口是旋转床的重要组成部分,对旋转床流场与气相压降有着重要的影响。研究并流旋转床结构、构建气体出口物理模型,利用RNG k-ε湍流模型,探索不同气体出口结构对并流旋转床流场的影响。模拟结果表明:具有4个切向气体出口的DCRPB3615型旋转床有利于旋转床内速度分布均匀、降低湍动能,减小气相压降。模拟与实验对比表明,DCRPB3615压降比单一径向出口的CRPB3615型旋转床降低10%左右。     

循环流化床锅炉燃煤技术热电厂生命周期评价

运用生命周期评价方法,应用Gabi5.0软件对采用循环流化床锅炉燃煤技术的热电企业进行资源耗竭和环境影响分析,计算各生产单元生命周期清单的全球变暖潜值、酸化效应潜值、富营养化潜值、非生物资源耗竭潜值、人体毒性潜值以及光化学烟雾和臭氧生成潜值等主要环境影响类型,对燃煤发电过程进行生命周期评价。结果表明,全球变暖和非生物资源耗竭为发电运行过程中主要的环境影响因素,分别占53%和15.05%;锅炉燃烧阶段的环境影响最重,占整个生命周期影响值的77.12%,并且除生物耗竭潜值外的其他5项指标均为发电运行阶段各个单元中最高。采用SNCR脱硝技术减少燃烧过程中NOx的排放量,并对该技术方案进行生命周期评价,比较方案实施前后的环境影响。     

生物滴滤塔处理模拟甲硫醚废气

在常温条件下,采用生物滴滤塔处理模拟甲硫醚废气,考察了气体空床停留时间(EBRT)、容积负荷、喷淋密度及营养液pH对生物滴滤塔性能的影响。实验结果表明:当EBRT为90 s、进气甲硫醚质量浓度为150 mg/m~3、喷淋密度为0.65 m~3/(m~2·h),营养液pH为6.8时,甲硫醚去除率为90%;容积负荷高于15 g/(m~3·h)时,对生物滴滤塔的性能产生抑制作用;EBRT为90 s及60 s时,最佳喷淋密度分别为0.56~0.65 m~3/(m~2·h)及0.65~0.75 m~3/(m~2·h);降解甲硫醚的微生物对pH的变化较敏感,最适营养液pH为6~7。     

阴极液及底物浓度对AFB-MFC同步废水处理及产电性能影响

为了提高厌氧流化床微生物燃料电池（AFB-MFC）的性能，并为双室MFC寻找价廉、易得、无污染的阴极液，在曝气量16～24 L/h、温度（35±2）℃、回流量10.2 L/h、阴极底边距阴极室内底部17.3 cm、外电阻250 Ω、水力停留时间（HRT）14.0～14.9 h以及进水pH 7.81～8.37下，研究了阴极液及底物浓度对系统产电及废水处理性能的影响。结果表明，使用缓冲溶液、阳极室出水和自来水作阴极液时，自来水的产电性能最佳，阴极液种类不影响系统有机基质的去除。以自来水为阴极液时，阴极液pH及电导率随运行时间增加而增加，COD去除率为80.11%～89.29%，输出电压及功率密度开始随运行时间增加而增加，之后稳定在440～452 mV和48.40～51.08 mW/m²之间。增加底物浓度对COD去除率影响不大，而输出电压及功率密度随底物浓度增加而下降；底物COD浓度由3 307.09 mg/L增至9 520 mg/L时，COD去除率在85.77%～94.44%之间，输出电压及功率密度则分别由449 mV和50.40 mW/m²下降至406 mV和41.21 mW/m²。自来水作阴极液可避免二次污染及阴极液对阳极室微生物的影响，并得到高的产电能力。